.png)
This post lists the steps to run the ZCU102 PetaLinux BSP on QEMU and rebuild it.
Prerequisites
PetaLinux 2017.4 installed. If you need help click here.
Steps
1. Download ZCU102 BSP (prod-silicon) from link.
You may also be able to get the BSP directly at direct link.
2. cd into the directory you download the BSP to.
3. Setup the PetaLinux Tools environment:
4. Create the PetaLinux Tools project based on the BSP
This command took about 15 seconds on my machine
5. Boot it on QEMU
After a minute or two you should see:
Type: root as the username and root as the password.
A log of this boot.
6. Exit QEMU
To exit QEMU type Control-a c then type quit
Control-a c enters the monitor (you can type Control-a c again to exit the monitor and get back to the emulated session).
Rebuild and rerun the BSP
1. Enter the directory and type petalinux-build
2. Run petalinux-boot with the --kernel option
A log of this boot.
References
PetaLinux Tools Documentation Reference Guide UG1144 (v2017.4) December 20, 2017
PetaLinux Tools Documentation Workflow Tutorial UG1156 (v2017.4) December 20, 2017
Logo via https://twitter.com/xilinxinc at link
Watch Out!
After you rebuild the PetaLinux BSP I had to use:
If I used:
It Didn't Work! Here's the boot log.
Here's the dump.
I get the following dumps when I try to boot: